Danfoss VLT FC 102 Programming Manual

Also see for VLT HVAC Drive FC 102: Operating instructions Service guide Programming guide Installation guide Installation guide

Contents

5.1.25 30-** Special FeaturesParameternumberParameter description Default value 4-set-up ChangeduringoperationConver-sion indexType30-2* Adv. Start Adjust30-22 Locked Rotor Detection ExpressionLimit All set-ups TRUE - Uint830-23 Locked Rotor Detection Time [s] ExpressionLimit All set-ups TRUE -2 Uint830-5* Unit Configuration30-50 Heat Sink Fan Mode ExpressionLimit 2 set-ups TRUE - uint830-8* Compatibility (I)30-85 Motor Frequency ExpressionLimit All set-ups FALSE -1 Uint3230-9* Wifi LCP30-90 SSID ExpressionLimit 1 set-up TRUE 0VisStr[32]30-91 Channel 5 N/A 1 set-up TRUE 0 Uint830-92 Password ExpressionLimit 1 set-up TRUE 0VisStr[48]30-93 Security type [2] WPA_WPA2 1 set-up TRUE - Uint830-94 IP address ExpressionLimit 1 set-up TRUE 0OctStr[4]30-95 Submask ExpressionLimit 1 set-up TRUE 0OctStr[4]30-96 Port 5001 N/A 1 set-up TRUE 0 Uint1630-97 Wifi Timeout Action [0] Do Nothing 1 set-up TRUE - Uint85.1.26 31-** Pressure Sensor/Bypass OptionParameternumberParameter description Default value 4-set-up Change duringoperationConver-sion indexType31-2* Configuration31-20 Pressure/Speed Curve Adjustment [0] None All set-ups TRUE - Uint831-21 Below level threshold ExpressionLimit All set-ups TRUE 0 Int1631-22 Above level threshold ExpressionLimit All set-ups TRUE 0 Int1631-23 On Delay Time 60 s All set-ups TRUE 0 Uint1631-24 Reset Delay Time 9999 s All set-ups TRUE 0 Uint1631-25 Pressure filter time constant 1 s All set-ups TRUE -2 Uint1631-2* Readouts31-26 Pressure Sensor 1 -5000 Pa All set-ups TRUE 0 Int1631-27 Pressure Sensor 2 -5000 Pa All set-ups TRUE 0 Int1631-28 Pressure Sensor 3 -5000 Pa All set-ups TRUE 0 Int1631-29 Pressure Sensor 4 -5000 Pa All set-ups TRUE 0 Int1631-30 Press Sens Cmp State 0 N/A All set-ups TRUE 0 Uint831-31 Press Sens toggle 0 N/A All set-ups TRUE 0 VisStr[21]31-3* Readout Conf.31-32 Toggled Readout Configuration [1] Enabled All set-ups TRUE - Uint831-33 Toggled Readout Text ExpressionLimit All set-ups TRUE 0 VisStr[12]5.1.27 32-** MCO Basic SettingsParameternumberParameter description Default value 4-set-up ChangeduringoperationConver-sion indexType32-9* Development32-90 Debug Source [0] Controlcard 2 set-ups TRUE - Uint8Parameter Lists Programming GuideM0010001 Danfoss A/S © 10/2019 All rights reserved. 3135 5