Menu item DescriptionNetwork BufferAuto3K to Sets the size of the network input bufferNotes:• Auto is the factory default setting.• The value can be changed in 1-K increments.• The maximum size allowed depends on the amount of memory in the printer,the size of the other link buffers, and whether Resource Save is set to On orOff.• To increase the maximum size range for the Network Buffer, disable or reducethe size of the parallel, serial, and USB buffers.• Changing this setting from the printer control panel and then exiting themenus causes the printer to restart. The menu selection is updated.Job BufferingOffOnAutoTemporarily stores jobs on the printer hard disk before printing. This menu onlyappears if a formatted disk is installed.Notes:• Off is the factory default setting.• The On value buffers jobs on the printer hard disk. This menu selection appearsonly when a formatted disk is installed and is not defective.• The Auto setting buffers print jobs only if the printer is busy processing datafrom another input port.• Changing this setting from the printer control panel and then exiting themenus causes the printer to restart. The menu selection is updated.Mac Binary PSOnOffAutoSets the printer to process Macintosh binary PostScript print jobsNotes:• Auto is the factory default setting.• The Off setting filters print jobs using the standard protocol.• The On setting processes raw binary PostScript print jobs.Std Network SetupReports or Network ReportsNetwork CardTCP/IPIPv6AppleTalkNetWareLexLinkNet SetupReports or Network ReportsNetwork CardTCP/IPIPv6WirelessAppleTalkNetWareLexLinkFor descriptions and settings of the network setup menus, see the following:• “Network Reports menu” on page 108• “Network Card menu” on page 108• “TCP/IP menu” on page 108• “IPv6 menu” on page 110• “Wireless menu” on page 110• “AppleTalk menu” on page 111• “NetWare menu” on page 111• “LexLink menu” on page 112Note: The Wireless menu appears only when the printer is connected to a wirelessnetwork.Understanding printer menus107
