Safety informationConnect the power cord to an electrical outlet that is near the product and easily accessible.Do not place or use this product near water or wet locations.CAUTION—POTENTIAL INJURY: This product uses a laser. Use of controls or adjustments or performance ofprocedures other than those specified herein may result in hazardous radiation exposure.This product uses a printing process that heats the print media, and the heat may cause the media to release emissions.You must understand the section in your operating instructions that discusses the guidelines for selecting print mediato avoid the possibility of harmful emissions.Use care when you replace a lithium battery.CAUTION—POTENTIAL INJURY: There is a danger of explosion if a lithium battery is incorrectly replaced.Replace it only with the same or an equivalent type of lithium battery. Do not recharge, disassemble, or incineratea lithium battery. Discard used batteries according to the manufacturer's instructions and local regulations.CAUTION—HOT SURFACE: The inside of the printer might be hot. To reduce the risk of injury from a hotcomponent, allow the surface to cool before touching.CAUTION—POTENTIAL INJURY: The printer weight is greater than 18 kg (40 lb) and requires two or moretrained personnel to move it safely.CAUTION—POTENTIAL INJURY: Before moving the printer, follow these guidelines to avoid personal injuryor printer damage:• Turn the printer off using the power switch, and then unplug the power cord from the wall outlet.• Disconnect all cords and cables from the printer before moving it.• Lift the printer off the optional drawer, and set it aside instead of trying to lift the drawer and printer at the sametime.Note: Use the handholds located on both sides of the printer to lift it off the optional drawer.Use only the power cord provided with this product or the manufacturer's authorized replacement.Use only the telecommunications (RJ-11) cord provided with this product or a 26 AWG or larger replacement whenconnecting this product to the public switched telephone network.CAUTION—SHOCK HAZARD: If you are accessing the system board or installing optional hardware or memorydevices sometime after setting up the printer, then turn the printer off, and unplug the power cord from thewall outlet before continuing. If you have any other devices attached to the printer, then turn them off as well,and unplug any cables going into the printer.CAUTION—SHOCK HAZARD: Make sure that all external connections (such as Ethernet and telephone systemconnections) are properly installed in their marked plug-in ports.This product is designed, tested, and approved to meet strict global safety standards with the use of specificmanufacturer's components. The safety features of some parts may not always be obvious. The manufacturer is notresponsible for the use of other replacement parts.CAUTION—POTENTIAL INJURY: Do not cut, twist, bind, crush, or place heavy objects on the power cord. Donot subject the power cord to abrasion or stress. Do not pinch the power cord between objects such as furnitureand walls. If any of these things happen, a risk of fire or electrical shock results. Inspect the power cord regularlyfor signs of such problems. Remove the power cord from the electrical outlet before inspecting it.Refer service or repairs, other than those described in the user documentation, to a professional service person.Safety information8
