4 From the pop-up menu, choose Installable Options.5 Add any installed hardware options, and then click Apply Changes.Setting up wireless printingInformation you will need to set up the printer on a wirelessnetworkNote: Do not connect the installation or network cables until prompted to do so by the setup software.• SSID—The SSID is also referred to as the network name.• Wireless Mode (or Network Mode)—The mode will be either infrastructure or ad hoc.• Channel (for ad hoc networks)—The channel defaults to auto for infrastructure networks.Some ad hoc networks will also require the auto setting. Check with your system support person if you are notsure which channel to select.• Security Method—There are three basic options for Security Method:– WEP keyIf your network uses more than one WEP key, enter up to four in the provided spaces. Select the key currentlyin use on the network by selecting the Default WEP Transmit Key.or– WPA or WPA2 passphraseWPA includes encryption as an additional layer of security. The choices are AES or TKIP. Encryption must beset for the same type on the router and on the printer, or the printer will not be able to communicate on thenetwork.– No securityIf your wireless network does not use any type of security, then you will not have any security information.Note: Using an unsecured wireless network is not recommended.If you are installing the printer on an 802.1X network using the Advanced method, then you may need the following:• Authentication type• Inner authentication type• 802.1X username and password• CertificatesNote: For more information on configuring 802.1X security, see the Networking Guide on the Software andDocumentation CD.Installing the printer on a wireless network (Windows)Before you install the printer on a wireless network, make sure that:• An optional wireless card is installed in your printer.• Your wireless network is set up and working properly.• The computer you are using is connected to the same wireless network where you want to set up the printer.Additional printer setup38
