Load with is a tray or feeder, and is a paper type or size.Try one or more of the following:• Load the paper tray or other source with the correct paper type and size.• Cancel the current job.Load staplesTry one or more of the following:• Replace the specified staple cartridge in the finisher.• Press the arrow buttons until Continue appears, and then press to clear the message and continue printing.• Cancel the print job.MaintenanceReplace the maintenance items and, if necessary, reset the printer maintenance counter.For information on purchasing supplies, see “Ordering supplies” on page 165.Menu access turned off by system administratorThe printer menus cannot be accessed because your system support person disabled the menus. Wait for the messageto clear.Menus are DisabledThe printer menus are disabled. The printer settings cannot be changed from the printer control panel. Contact yoursystem support person for help.Note: When menus are disabled, it is still possible to cancel a print job, print a confidential job, or print a held job.Must be in Ready state to enter menusThe printer menus cannot be accessed at this time because the printer control panel does not show the Readymessage. Wait for the printer to complete its activity. When Ready appears, press .Network/Network /Network , The printer is connected to the network, so the network interface is the active communication link.• Network indicates that the printer is using the standard network port built into the printer system board.• Network indicates that an internal print server is installed inside the printer or that the printer is connectedto an external print server.Understanding printer messages148
