Notes:• Do not exceed the maximum stack height by forcing paper under the stack height limiter.• Do not load or close the printer while a job is printing.• Load only one size and type of media at a time.• Load envelopes with the flap side down and to the left as shown on the tray.Warning—Potential Damage: Never use envelopes with stamps, clasps, snaps, windows, coated linings, orself-stick adhesives. These envelopes may severely damage the printer.6 Adjust the width guide to lightly touch the edge of the paper stack. Make sure the paper fits loosely in themultipurpose feeder, lies flat, and is not bent or wrinkled.7 From the printer control panel, set the Paper Size and Paper Type.Loading the envelope feeder1 Adjust the envelope support for the length of envelope you are loading:• Short envelopes—Fully close the envelope support.• Medium-length envelopes—Extend the envelope support to the middle position.• Long envelopes—Fully open the envelope support.2 Lift the envelope weight back toward the printer.Loading paper and specialty media59
