Viewing reportsYou can view some reports from the Embedded Web Server. These reports are useful for assessing the status of theprinter, the network, and supplies.To view reports from a network printer:1 Type the printer IP address into the address field of your Web browser.Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP addressin the TCP/IP section.2 Click Reports, and then click the type of report you want to view.Adjusting Power SaverAvailable settings range from 1–240 minutes. The factory default is 30 minutes.To increase or decrease the number of minutes before the printer enters Power Saver mode, do one of the following:Using the Embedded Web Server1 Type the printer IP address into the address field of your Web browser.Note: If you do not know the IP address of the printer, then print a network setup page and locate the IP addressin the TCP/IP section.2 Click Settings, and then click General Settings.3 Click Timeouts.4 In the Power Saver box, increase or decrease the number of minutes you want the printer to wait before it entersPower Saver mode.5 Click Submit.Using the printer control panel1 Make sure the printer is on and Ready appears.2 Press .3 Press the arrow buttons until Settings appears, and then press .4 Press the arrow buttons until General Settings appears, and then press .5 Press the arrow buttons until Timeouts appears, and then press .6 Press the arrow buttons until Power Saver appears, and then press .7 Press the arrow buttons to increase or decrease the number of minutes before the printer enters Power Savermode, and then press .Administrative support168
