CONFIGURATION ECMP-GROUP modeinterface interface interface tengigabitethernet 1/1/1 interface port-channel 1003. Enable monitoring for the bundle.CONFIGURATION ECMP-GROUP modelink-bundle-monitor enableModifying the ECMP Group ThresholdYou can customize the threshold percentage for monitoring ECMP group bundles.To customize the ECMP group bundle threshold and to view the changes, use the following commands.• Modify the threshold for monitoring ECMP group bundles.CONFIGURATION modelink-bundle-distribution trigger-threshold {percent}The range is from 1 to 90%.The default is 60%.• Display details for an ECMP group bundle.EXEC modeshow link-bundle-distribution ecmp-group ecmp-group-idThe range is from 1 to 64.Viewing an ECMP GroupNOTE: An ecmp-group index is generated automatically for each unique ecmp-group when youconfigure multipath routes to the same network. The system can generate a maximum of 512unique ecmp-groups. The ecmp-group indices are generated in even numbers (0, 2, 4, 6... 1022)and are for information only.You can configure ecmp-group with id 2 for link bundle monitoring. This ecmp-group is differentfrom the ecmp-group index 2 that is created by configuring routes and is automatically generated.These two ecmp-groups are not related in any way.Dell(conf-ecmp-group-5)#show config!ecmp-group 5interface tengigabitethernet 1/2/1interface tengigabitethernet 1/3/1link-bundle-monitor enableDell(conf-ecmp-group-5)#Support for /128 IPv6 and /32 IPv4 Prefixes in Layer 3 Host Table and LPMTableIPv6 enhancements utilize the capability on S6000 platform to program /128 IPv6 prefixes in LPM tableand /32 IPv4 prefixes in Host table. Also host table provides ECMP support for destination prefixes in theEqual Cost Multi-Path (ECMP) 311
