Host Flags TTL Type Address-------- ----- ---- ---- -------ks (perm, OK) - IP 2.2.2.2patch1 (perm, OK) - IP 192.68.69.2tomm-3 (perm, OK) - IP 192.68.99.2gxr (perm, OK) - IP 192.71.18.2f00-3 (perm, OK) - IP 192.71.23.1Dell>To view the current configuration, use the show running-config resolve command.Specifying the Local System Domain and a List ofDomainsIf you enter a partial domain, Dell Networking OS can search different domains to finish or fully qualifythat partial domain.A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. Dell NetworkingOS searches the host table first to resolve the partial domain. The host table contains both staticallyconfigured and dynamically learnt host and IP addresses. If Dell Networking OS cannot resolve thedomain, it tries the domain name assigned to the local system. If that does not resolve the partial domain,Dell Networking OS searches the list of domains configured.To configure a domain name or a list of domain names, use the following commands.• Enter up to 63 characters to configure one domain name.CONFIGURATION modeip domain-name name• Enter up to 63 characters to configure names to complete unqualified host names.CONFIGURATION modeip domain-list nameConfigure this command up to six times to specify a list of possible domain names. Dell NetworkingOS searches the domain names in the order they were configured until a match is found or the list isexhausted.Configuring DNS with TracerouteTo configure your switch to perform DNS with traceroute, use the following commands.• Enable dynamic resolution of host names.CONFIGURATION modeip domain-lookup• Specify up to six name servers.CONFIGURATION modeip name-server ip-address [ip-address2 ... ip-address6]The order you entered the servers determines the order of their use.• When you enter the traceroute command without specifying an IP address (ExtendedTraceroute), you are prompted for a target and source IP address, timeout in seconds (default is 5),a probe count (default is 3), minimum TTL (default is 1), maximum TTL (default is 30), and port number(default is 33434).426 IPv4 Routing
