Configuring IPv6 RA Guard on an InterfaceTo configure the IPv6 Router Advertisement (RA) guard on an interface, perform the following steps:1. Configure the terminal to enter the Interface mode.CONFIGURATION modeinterface interface-type slot/port[/subport]2. Apply the IPv6 RA guard to a specific interface.INTERFACE modeipv6 nd ra-guard attach policy policy-name [vlan [vlan 1, vland 2, vlan3.....]]3. Display the configurations applied on all the RA guard policies or a specific RA guard policy.EXEC Privilege modeshow ipv6 nd ra-guard policy policy-nameThe policy name string can be up to 140 characters.Example of the show ipv6 nd ra-guard policy CommandDell#show ipv6 nd ra-guard policy testipv6 nd ra-guard policy testdevice-role routerhop-limit maximum 1match ra ipv6-access-list accessother-config-flag onrouter-preference maximum mediumtrusted-portInterfaces :Te 1/1/1Dell#Monitoring IPv6 RA GuardTo debug IPv6 RA guard, use the following command.EXEC Privilege modedebug ipv6 nd ra-guard [interface slot/port[/subport] | count value]The count range is from 1 to 65534. The default is infinity.For a complete listing of all commands related to IPv6 RA Guard, see the Dell Networking OSCommand Line Reference Guide.IPv6 Routing 459
