VLAN ID: the range is from 1 to 4094.2. Tag the specified interface or range of interfaces to this VLAN.CONFIG-INT-VLAN mode.tagged interface slot/port[/subport] {range}Interface:• Slot/Port[/subport]: Slot and Port ID for the interface. Range is entered Slot/Port[/subport]-Slot/Port[/subport].• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/portinformation.3. Assign the Primary and Secondary ports and the Control VLAN for the ports on the ring.CONFIG-FRRP mode.interface primary interface slot/port[/subport] secondary interface slot/port[/subport] control-vlan vlan idInterface:• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port/subport information.• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/portinformation.• [/subport]Slot/Port[/subport]: Slot and Port ID for the interface. Range is entered Slot/Port[/subport]-Slot/Port[/subport].VLAN ID: Identification number of the Control VLAN.4. Configure a Transit node.CONFIG-FRRP mode.mode transit5. Identify the Member VLANs for this FRRP group.CONFIG-FRRP mode.member-vlan vlan-id {range}VLAN-ID, Range: VLAN IDs for the ring’s Member VLANs.6. Enable this FRRP group on this switch.CONFIG-FRRP mode.no disableSetting the FRRP TimersTo set the FRRP timers, use the following command.NOTE: Set the Dead-Interval time 3 times the Hello-Interval.Force10 Resilient Ring Protocol (FRRP) 345
