• Return to the default setting.CONFIGURATION mode or INTERFACE modeno modeExample of Configuring a Single ModeR1(conf)#protocol lldpR1(conf-lldp)#show config!protocol lldpadvertise dot1-tlv port-protocol-vlan-id port-vlan-idadvertise dot3-tlv max-frame-sizeadvertise management-tlv system-capabilities system-descriptionno disableR1(conf-lldp)#mode ?rx Rx onlytx Tx onlyR1(conf-lldp)#mode txR1(conf-lldp)#show config!protocol lldpadvertise dot1-tlv port-protocol-vlan-id port-vlan-idadvertise dot3-tlv max-frame-sizeadvertise management-tlv system-capabilities system-descriptionmode txno disableR1(conf-lldp)#no modeR1(conf-lldp)#show config!protocol lldpadvertise dot1-tlv port-protocol-vlan-id port-vlan-idadvertise dot3-tlv max-frame-sizeadvertise management-tlv system-capabilities system-descriptionno disableR1(conf-lldp)#Configuring the Time to Live ValueThe information received from a neighbor expires after a specific amount of time (measured in seconds)called a time to live (TTL).The TTL is the product of the LLDPDU transmit interval (hello) and an integer called a multiplier. Thedefault multiplier is 4, which results in a default TTL of 120 seconds.• Adjust the TTL value.CONFIGURATION mode or INTERFACE mode.multiplier• Return to the default multiplier value.CONFIGURATION mode or INTERFACE mode.no multiplierExample of the multiplier Command to Configure Time to LiveR1(conf-lldp)#show config!protocol lldpadvertise dot1-tlv port-protocol-vlan-id port-vlan-idadvertise dot3-tlv max-frame-sizeLink Layer Discovery Protocol (LLDP) 541
