Interface: TenGigabitEthernet 1/1/1Link Local address: fe80::201:e8ff:fe40:4d10IPSecv6 policy name: OSPFv3-1-500inbound ah sasspi : 500 (0x1f4)transform : ah-md5-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVEoutbound ah sasspi : 500 (0x1f4)transform : ah-md5-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVEinbound esp sasoutbound esp sasInterface: TenGigabitEthernet 1/2/1Link Local address: fe80::201:e8ff:fe40:4d11IPSecv6 policy name: OSPFv3-1-600inbound ah sasoutbound ah sasinbound esp sasspi : 600 (0x258)transform : esp-des esp-sha1-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVEoutbound esp sasspi : 600 (0x258)transform : esp-des esp-sha1-hmacin use settings : {Transport, }replay detection support : NSTATUS : ACTIVETroubleshooting OSPFv3The system provides several tools to troubleshoot OSPFv3 operation on the switch. This sectiondescribes typical, OSPFv3 troubleshooting scenarios.NOTE: The following troubleshooting section is meant to be a comprehensive list, but only toprovide some examples of typical troubleshooting checks.• Have you enabled OSPF globally?• Is the OSPF process active on the interface?• Are the adjacencies established correctly?• Did you configure the interfaces for Layer 3 correctly?• Is the router in the correct area type?• Did you include the routes in the OSPF database?• Did you include the OSPF routes in the routing table (not just the OSPF database)?Some useful troubleshooting commands are:Open Shortest Path First (OSPFv2 and OSPFv3) 655
