To enable FCoE transit on the switch and configure the FCoE transit parameters on ports, follow thesesteps.1. Configure FCoE.FCoE configuration:copy flash:/ CONFIG_TEMPLATE/ FCoE_DCB_Config running-configThe configuration files are stored in the flash memory in the CONFIG_TEMPLATE file.NOTE: DCB/DCBx is enabled when either of these configurations is applied.2. Save the configuration on the switch.EXEC Privilege mode.write memory3. Reload the switch to enable the configuration.EXEC Privilege mode.reloadAfter the switch is reloaded, DCB/DCBx is enabled.4. Enable the FCoE transit feature on a switch.CONFIGURATION mode.feature fip-snooping5. Enable FIP snooping on all VLANs or on a specified VLAN.CONFIGURATION mode or VLAN INTERFACE mode.fip-snooping enable6. Configure the port for bridge-to-FCF links.INTERFACE mode or CONFIGURATION modefip-snooping port-mode fcfNOTE: To disable the FCoE transit feature or FIP snooping on VLANs, use the no version of acommand; for example, no feature fip-snooping or no fip-snooping enable.Displaying FIP Snooping InformationUse the following show commands to display information on FIP snooping.Table 28. Displaying FIP Snooping InformationCommand Outputshow fip-snooping sessions [interfacevlan vlan-id]Displays information on FIP-snooped sessions onall VLANs or a specified VLAN, including the ENodeinterface and MAC address, the FCF interface andMAC address, VLAN ID, FCoE MAC address andFCoE session ID number (FC-ID), worldwide nodeFCoE Transit 321
