ip redirect-list redirect-list-nameredirect-list-name: 16 characters.To delete the redirect list, use the no ip redirect-list command.The following example creates a redirect list by the name of xyz.Dell(conf)#ip redirect-list ?WORD Redirect-list name (max 16 chars)Dell(conf)#ip redirect-list xyzCreate a Rule for a Redirect-listTo set the rules for the redirect list, use the following command. You can enter the command multipletimes and create a sequence of redirect rules. Use the seq nn redirect version of the command toorganize your rules.Configure a rule for the redirect list.CONF-REDIRECT-LIST modeseq {number} redirect {ip-address | tunnel tunnel-id} [track }{ip-protocol-number | protocol-type [bit]} {source mask | any | host ip-address}{destination mask | any | host ip-address}• number is the number in sequence to initiate this rule• ip-address is the Forwarding router’s address• tunnel is used to configure the tunnel settings• tunnel-id is used to redirect the traffic• track is used to track the object-id• track is to enable the tracking• FORMAT: A.B.C.D• FORMAT: slot/port/subport• ip-protocol-number or protocol-type is the type of protocol to be redirected• FORMAT: 0-255 for IP protocol number, or enter protocol type• source ip-address or any or host ip-address is the Source’s IP address• FORMAT: A.B.C.D/NN, or ANY or HOST IP address• destination ip-address or any or host ip-address is the Destination’s IP address• FORMAT: A.B.C.D/NN, or ANY or HOST IP addressTo delete a rule, use the no redirect command.The redirect rule supports Non-contiguous bitmasks for PBR in the Destination router IP addressThe following example shows how to create a rule for a redirect list by configuring:• IP address of the next-hop router in the forwarding route• IP protocol number• Source address with mask information• Destination address with mask information660 Policy-based Routing (PBR)
