In Domain 1, configure Peer 1 fist, then configure Peer 2. When that is complete, perform the same stepsfor the peer nodes in Domain 2. The interface used in this example is TenGigabitEthernet.Figure 129. eVLT Configuration ExampleeVLT Configuration Step ExamplesIn Domain 1, configure the VLT domain and VLTi on Peer 1.Domain_1_Peer1#configureDomain_1_Peer1(conf)#interface port-channel 1Domain_1_Peer1(conf-if-po-1)# channel-member TenGigabitEthernet 1/8/1-1/8/2Domain_1_Peer1(conf)#vlt domain 1000Domain_1_Peer1(conf-vlt-domain)# peer-link port-channel 1Domain_1_Peer1(conf-vlt-domain)# back-up destination 10.16.130.11Domain_1_Peer1(conf-vlt-domain)# system-mac mac-address 00:0a:00:0a:00:0aDomain_1_Peer1(conf-vlt-domain)# unit-id 0Configure eVLT on Peer 1.Domain_1_Peer1(conf)#interface port-channel 100Domain_1_Peer1(conf-if-po-100)# switchportDomain_1_Peer1(conf-if-po-100)# vlt-peer-lag port-channel 100Domain_1_Peer1(conf-if-po-100)# no shutdownAdd links to the eVLT port-channel on Peer 1.Domain_1_Peer1(conf)#interface range tengigabitethernet 1/16/1 - 1/16/2Domain_1_Peer1(conf-if-range-te-1/16-17/1)# port-channel-protocol LACPDomain_1_Peer1(conf-if-range-te-1/16-17/1)# port-channel 100 mode activeDomain_1_Peer1(conf-if-range-te-1/16-17/1)# no shutdownNext, configure the VLT domain and VLTi on Peer 2.Domain_1_Peer2#configureDomain_1_Peer2(conf)#interface port-channel 1Domain_1_Peer2(conf-if-po-1)# channel-member TenGigabitEthernet 1/8/1-1/8/2Domain_1_Peer2(conf) #vlt domain 1000Domain_1_Peer2(conf-vlt-domain)# peer-link port-channel 1952 Virtual Link Trunking (VLT)
