To view the Primary RPM Management port, use the show interface Managementethernetcommand in EXEC Privilege mode. If there are two RPMs, you cannot view information on that interface.Configuring a Management Interface on an Ethernet PortYou can manage the system through any port using remote access such as Telnet.To configure an IP address for the port, use the following commands. There is no separate managementrouting table, so configure all routes in the IP routing table (the ip route command).• Configure an IP address.INTERFACE modeip address• Enable the interface.INTERFACE modeno shutdown• The interface is the management interface.INTEFACE modedescriptionExample of the show interface and show ip route CommandsTo display the configuration for a given port, use the show interface command in EXEC Privilegemode, as shown in the following example. To display the routing table, use the show ip routecommand in EXEC Privilege mode.Dell#show int TenGigabitEthernet 1/1/1TenGigabitEthernet 1/1/1 is up, line protocol is upDescription: This is the Managment InterfaceHardware is Force10Eth, address is 00:01:e8:cc:cc:ceCurrent address is 00:01:e8:cc:cc:cePluggable media not presentInterface index is 46449666Internet address is 10.11.131.240/23[output omitted]Dell#show ip routeCodes: C - connected, S - static, R - RIP,B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,> - non-active route, + - summary routeGateway of last resort is 10.11.131.254 to network 0.0.0.0Destination Gateway Dist/Metric Last Change----------- ------- ----------- -----------*S 0.0.0.0/0 via 10.11.131.254, Te 1/1/1 1/0 1d2hC 10.11.130.0/23 Direct, Te 1/1/1 0/0 1d2hDell#386 Interfaces
