Eaton 9PXM8S4K User Manual

Also see for 9PXM: Manual User guide User guide

12 4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 101. Select the location for the brackets at the floor intersection beside the intended cabinet location.2. Attach the brackets to the cabinet base as shown in Figure 9 .3. Roll the UPS cabinet to its intended location. Position the rear section of the cabinet base under the openends of the stabilizer brackets as far as the cabinet will go.4. Turn all four leveling feet counter-clockwise until the cabinet is level.5. Using the proper type of customer-supplied screws for the intended mounting surface, attach eachbracket as shown in Figure 9 . All screws must be properly driven into the structural material.Figure 9. Floor Anchor Bracket InstallationFloor AnchorBracketFloor BoltSlotsMount BoltsSpacerLevelingFoot*Installation to be updated(spacers/bolts)22..66 RRaacckk--MMoouunntt IInnssttaallllaattiioonnThe 12-slot UPS weighs 93 kg (204 lb) with the caster cart. Install the cabinet in the rack before installing powerand battery modules and before making connections to the intended power source.The Eaton 9PXM UPS and the battery cabinet are very heavy with power modules and two battery modules perslot installed. If installed, before moving the cabinets, remove the power modules and battery two batterymodules per slot (see “9.1 Routine Maintenance ” ).Rack-Mount Installation