Eaton 9PXM8S4K User Manual

Also see for 9PXM: Manual User guide User guide

24 4–20kVA Users Guide P-164000669 4–20kVA Users Guide P-164000669—Rev 10NOTE Make a note to enable Forced and Maintenance Bypass per the following step wheninstallation is complete and power available.c. Navigate the 9PXM LCD to the forced and maintain bypass settings Input signals menu in the 9PXMuser guide (see Figure 23 ).d. Set both Forced Bypass and Maintain Bypass settings to Enabled and Normally open (see Figure 23 ).Figure 23. Forced and Maintenance Bypass Screens”orceg7ypassDrygcontactgsetting;nabled>olarityjormallygopen±enu±easurements8ontrol"ettings;ventg+og”aultg+og[dentihcation@egistergproduct"ettings[nK+ocalgsettings7atterygsettings[nputg"ignals8ommg"ettings?serg>asswordg;nable?serg>asswordgsetting±aintaing7ypassDrygcontactgsetting;nabled>olarityjormallygopeng;fhciencyzgTFMyMyCykYyCyk’5LyyMLTminL;7±+oadgnotgpowered5. Install the supplied wiring connectors to the UPS input control signal wires and connect to the terminals asshown in or .6. When all connections have been made and checked, reinstall the bypass switch front cover using theoriginal screws.7. If floor anchor brackets were installed and not secured, install the floor bolts.BPM Signal Input Wire Routing