Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

Setting and UnsettingPage 82. The bottom line shows the first setting option:3. Press  or  followed by  to select the option you require:Full Set – To set the whole system. Alternatively, press the A key.Part Set B\C\D – To set part set B, C or D only. Alternatively, pressthe B, C or D key.4. If you see a fault warning such as:a) Press  to override the warning and continue setting (if yourinstaller has allowed this).b) Contact your installer for assistance.You may see a setting fault (such as an active zone) that prevents youfrom setting the system. Normally, the system can set only whenzones (other than those in the entry/exit route) are inactive.5. You will hear a continuous exit tone (unless the system is configuredfor silent or instant setting).If you have the final exit door open, or you trigger one of the detectorson your entry/exit route, internal sounders (including the sounder inthe control unit) give an interrupted setting tone (this is normal).The system sets when one of the following occurs, depending on howthe system is configured: Immediately (instant set). After a specified period of time. You need to make sure you exitthe premises before the exit timer expires. The bottom lineshows the remaining time: When you have exited the premises.Note: You can press the  key to stop the system setting before it has set.