Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

Setting and UnsettingPage 9How do I know that the system is set?When the system sets the keypad briefly shows:After a short period, the standby screen is displayed. For example:One of the four LEDs (Figure 2) may glow to show which part of the systemis set, unless disabled by the installer to meet appropriate standards.In addition, the installer may have configured the system to flash the strobelight briefly on the external siren/strobe unit when the system sets.Quick-setting from the control unitYour installer may have enabled quick-setting, which removes the need touse an access code or proximity tag to start setting.Note: To make the system comply with certain regulations, the installermay not be allowed to provide this facility.To quick set (if enabled):1. Press:A – To set the system fully.B – To set part set B.C – To set part set C.D – To set part set D.2. You will hear a continuous exit tone (unless the system is configuredfor silent or instant setting). The system sets as described in step 5 onpage 8.Unsetting from the control unit1. Enter through the entry route designated by the installer (this isusually the same as you used to leave the premises). Do not strayfrom this route – you may cause an alarm.2. Depending on how the system is configured, you may hear an entrytone. If you hear a tone, go directly to the control unit, since you willhave limited time to unset the system before it generates an alarm.