Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

Page ii© Eaton 2017The information, recommendations, descriptions and safety notations in this document arebased on Eaton Corporation’s (“Eaton”) experience and judgment and may not cover allcontingencies. If further information is required, an Eaton sales office should be consulted.Sale of the product shown in this literature is subject to the terms and conditions outlined inappropriate Eaton selling policies or other contractual agreement between Eaton and thepurchaser.THERE ARE NO UNDERSTANDINGS, AGREEMENTS, WARRANTIES, EXPRESSED ORIMPLIED, INCLUDING WARRANTIES OF FITNESS FOR A PARTICULAR PURPOSE ORMERCHANTABILITY, OTHER THAN THOSE SPECIFICALLY SET OUT IN ANY EXISTINGCONTRACT BETWEEN THE PARTIES. ANY SUCH CONTRACT STATES THE ENTIREOBLIGATION OF EATON. THE CONTENTS OF THIS DOCUMENT SHALL NOT BECOMEPART OF OR MODIFY ANY CONTRACT BETWEEN THE PARTIES.In no event will Eaton be responsible to the purchaser or user in contract, in tort (includingnegligence), strict liability or other-wise for any special, indirect, incidental or consequentialdamage or loss whatsoever, including but not limited to damage or loss of use of equipment,plant or power system, cost of capital, loss of power, additional expenses in the use of existingpower facilities, or claims against the purchaser or user by its customers resulting from the useof the information, recommendations and descriptions contained herein. The informationcontained in this manual is subject to change without notice.Compliance StatementThe i-on Compact control unit is: Suitable for use in systems designed to comply with PD6662:2010 at Grade 2 andenvironmental class II. Suitable for use in systems designed to comply with the requirements of EN50131-3 atGrade 2 and environmental class II. Compliant with the requirements of EN50131-6:2008 at Grade 2 and environmentalclass II.When an appropriate communicator is enabled, the control unit is compliant with EN 50136-1.It allows the alarm transmission system to meet the performance requirements of EN 50131-1:2006 ATS 2 provided that:a) The equipment is installed in accordance with the installation instructions.b) The communications link is functioning normally.If the installer selects a non-compliant configuration, they must remove or adjust compliancelabelling.Warning: Mains voltages are present inside control unit. Nouser serviceable parts inside.