Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

Setting and UnsettingPage 11The installer can use a 2W Set Instant option to choose whether the remotecontrol should set instantly or follow the configured exit mode (such as atimed set).Operating the buttonsTo ensure that the remote control does not accidentally operate while it isin your pocket, the buttons are deliberately slow to respond to pressure.You must hold down the button you intend to press for at least threeseconds to activate its function.See page 40 for details of programming the * button.Setting the system using a remote control1. Make sure the system is in standby.2. Press and hold the Set or Part Set button, as required. The Set or PartSet LED flashes red three times.If there is a fault (for example a zone is active), all four LEDs glow redfor three seconds.3. You will hear a continuous exit tone (unless the system is configuredfor silent or instant setting). The system sets as described in step 5 onpage 8.4. The Set or Part Set LED glows green for three seconds. This is yourconfirmation that the control unit has set the system.Unsetting the system using a remote controlNote: An administrator can disable the ability for remote controls to unsetthe system (see page 43).To unset the system:1. Enter through the entry route designated by the installer.2. Depending on how the system is configured, you may hear an entrytone. If you hear the tone, you will have limited time to unset thesystem before it generates an alarm.3. Press and hold the Unset button. The Unset LED flashes red threetimes.4. The Unset LED glows green for three seconds. This is yourconfirmation that the control unit has unset the system.