Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

User Menu OptionsPage 43Enabling or disabling unsettingYou can use System Config – Remotes – Unset to enable or disable theability for all remote controls to unset the system. By default, remotecontrols are able to unset the system, but you may want to change this forsecurity reasons.After selecting Unset, use  or  to select Enabled or Disabled, followedby .Disabling Unset does not affect the ability for remote controls to set thesystem.Enabling or disabling HUA functionsYou can use System Config – Remotes – HUA Function to enable ordisable the ability for a two-way remote control to generate Hold-Up Alarms(HUAs).Note: The installer must first enable this feature by configuring "Basic"confirmation mode. Doing so means that the system does not comply withBS8243 or DD243.After selecting HUA Function, use  or  to select Enabled or Disabled,followed by .See page 12 for details of how to generate an HUA using a two-wayremote control.Switching outputs on/offMaster users can use Outputs On/Off to switch outputs on or off that theinstaller has configured as "User Defined" as follows:1. Select Outputs On/Off.The display lists any outputs allocated for your use. For example:The top line shows the output number. The bottom line shows thename of the output and whether the output is currently on or off.2. Press  or  to select the output.3. Press  or  to switch the output on or off. Outputs operated viaradio may take several seconds to change state.4. Press  repeatedly to exit.

/ 50

Related manuals for Eaton i-on Compact