Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

User Menu OptionsPage 32Performing a walk testMaster users can use Test – Walk Test to test detectors without starting analarm. Walking past motion detectors should be enough to trigger them. Ifyou have detectors connected to doors or windows, you will have to openthem to trigger those detectors.During the test, if the detector is working, the control unit sounds aconfirmation tone and indicates that the detector has passed the test.Note: You cannot test wired HUA buttons, fire detectors and 24-hour zonesduring a walk test. The control unit will always start an alarm if you activatethose detectors.To carry out the test:1. Select Test – Walk Test.2. With the Chime option highlighted, use  or  to select one of thefollowing:Once Causes the sounder in the control unit to chime only oncefor each zone that is triggered during the walk test.Off Switches off chiming.On Generates a chime every time a zone is triggered.3. Press  or  followed by  to select the method of testing:System This option allows you to walk round the entire system andtest all the zones.Zones This option lets you select one or more individual zones,and test only those zones.Press  or  to scroll up and down the list of zones. Press to display “Yes” at the end of the bottom line to mark thezone as one you want to test.4. Press  to begin the test.The top line shows how many detectors remain to be tested. The mainarea of the display lists of all the detectors ready for testing (press or  to scroll through the zones):