Eaton i-on Compact Administration And User Manual

Also see for i-on Compact: User guide Quick setup guide Administration and User Manual Administration and User Manual

Contents

User Menu OptionsPage 41 Full set the whole system (one-way remote control only). Unset the whole system (one-way remote control only).Note: For one-way remote controls, you cannot reprogram the unsetbutton.To re-program the buttons on a remote control:1. Select System Config – Remotes – Edit.The following is displayed:2. EITHER:a) Press the button on the remote control you want to re-program.Hold down the button until you see the transmit LED flash.OR (if you do not have the remote control):a) Press  at the "Press Remote button" prompt.b) Use  or  followed by  to select the remote control youwant to re-program.c) Use  or  followed by  to select the button you wish to re-program (if there is more than one you can select).3. Use  or  followed by  to choose the function for the button:No Action For the button to have no action.Set/Unset (two-way remote control only): To set part set B/C/D. Press, then use  or  followed by  to select the part set.(The * key cannot be used to unset.)Set/Unset (one-way remote control only): To set or unset the system.Choose Set or Unset, then use  or  followed by  toselect the set/unsetting mode: Unset All – Unsets the whole system. Full Set – Full sets the whole system. Part Set B\C\D – Sets part set B, C or D.Note: If you choose Unset, ask your installer whether theentry timer needs to be running before a user can unsetusing a remote control.