RESTRICTED USE ONLY Fargo Electronics, Inc.HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 4-15Magnetic and E-card Troubleshooting GuideProblem Possible SolutionStart Sentinel isyellow or redChange the magnetic TOF in the LCD according to the startsentinel reference chartVerify correct mag Module placement. The mag Module should beadjusted so that the belt (F000111) is snug prior to installing thetensioner.Verify correct tension of the belt (F000111). Belt should haveapproximately 1/8 deflection at the center point between pulleysRandom yellow orred readings on eachtrackVerify correct tension of the belt (F000111). Belt should haveapproximately 1/8 deflection at the center point between pulleysVerify the belt (F000111) is riding in the middle of the press onpulleys (D850190). Adjust position so the press on pulleys areparallel / even.Check that all wires are free from any gearsVerify Mag Voltage is @ 6 volts for Hi-Co, 3 Volts for Lo-Co andJIS2.Verify that the belts (F000092 and F000094) are not catching /rubbing against the edges of the pulleys (D850221 and D840888).Verify the belts (F000092 and F000094) are tensioned properly.Try replacing the input stepper (E000062)Random yellow orred readings with aspike in the bitsAdjust the magnetic TOF down (closer to the ideal .293) if a spikeis occurring at the end of the card.Verify correct Magnetic Module placement. The Magnetic Moduleshould be adjusted so that the belt (F000111) is snug prior toinstalling the tensioner.Verify the card is not running into the Flipper Table. Check thealignment of the Flipper Table / Flipper Offset.Inspect all gears on the input hopper drive train for damaged teethWith cleaning Roller removed, verify all gears roll smoothly and donot bind.Check that all gears are free from wires.Continued on the next page
