RESTRICTED USE ONLY Fargo Electronics, Inc.HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 12-4Updating the Printer's FirmwareNow that you have installed and opened the Firmware Updater program and downloaded theFirmware update file, you can begin updating your Printer's Firmware.It is important to note that there are two types of Firmware for certain Fargo Printer models,the Main Firmware and the LCD Firmware, each of which has a slightly different updateprocess.Updating the Main FirmwareStep Procedure1 If you haven't already done so, select Start -> Programs -> Fargo and openthe Firmware Updater program. From the Firmware Updater program, clickthe Select Update File button, as shown below in the Firmware Updater(Version 3.0.6) window.2 Go to the folder, in which you saved the update file, select it and click Open.(Note: The file name, location and version will appear in the FirmwareUpdater window, as shown below.)3 Click the Select Printer button and select the specific Fargo Printer model,click OK. Once your Printer model has been selected, the Send Updatebutton will become active.4 At this time, the Printer must be prepared to receive the Firmware update file.To do this, make sure the Printer is powered ON and in its READY mode.Then, press the Printer's MENU button.5 Use the scroll buttons to scroll down to the System Upgrade option andpress SELECT.When the Printer asks if you would like to continue, press YES.6 a. Wait while the Printer restarts into the System Upgrade mode.b. Verify that the interface cable is securely connected to both the Printerand the computer and press the START button. The Printer will wait up to 60 seconds to receive the Firmware updatebefore timing out. The clock will be indicated on the LCD Display.7 From the Firmware Updater software, click the Send Update button to bringup the Firmware Updater dialog box, as shown below.
