RESTRICTED USE ONLY Fargo Electronics, Inc.HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) 12-7Updating the LCD FirmwareStep Procedure1 Make sure the Printer is powered ON, connected to the PC and in its READYmode.2 From the Firmware Updater program, click on the Select Update File button.3 Go to the folder, in which you saved the update file, select it and click Open.The file name, location and version will appear in the Firmware Updaterwindow, as shown below.4 Click on the Select Printer button and select the specific Fargo Printermodel, click OK.5 Click on the Send Update button to bring up the Firmware Updater dialogbox, as shown below.6 Wait a few minutes while the Firmware updates itself. Check the Printer'sLCD for the status. When the update is complete, the LCD will indicate if theupdate was successful. If Upgrade Successful is displayed, click Exit on the Sending Updateto Printer dialog screen. Press the Printer's EXIT button. Whenprompted, turn the Printer power OFF for a few seconds and then backON to complete the update process. As the Printer restarts, you will seethe new Firmware version appear on the LCD. If the upgrade was not successful, the LCD will display Upgrade Failedor Upgrade Firmware Now on boot up. If you receive this message, try updating the Firmware again.
