RESTRICTED USE ONLY Fargo Electronics, Inc.HDP600 High Definition Card Printer/Encoder User Guide (Rev. 2.3) viiAdjusting the Transfer Dwell Time and Transfer Temperature _____________________________ 7-71Selecting the Sensors button and Defaults button________________________________________ 7-71Selecting the Sensors button and Defaults button________________________________________ 7-72Section 8: Cleaning ________________________________________________________ 8-1Table of Contents ___________________________________________________________________ 8-1Using the Required Supplies ________________________________________________________ 8-2Safety Messages (review carefully)______________________________________________________ 8-3Cleaning inside the Printer __________________________________________________________ 8-4Cleaning outside the Printer _________________________________________________________ 8-4Cleaning the Printhead _____________________________________________________________ 8-5Replacing the Card Cleaning Tape ____________________________________________________ 8-6Cleaning the Magnetic Encoder ______________________________________________________ 8-8Cleaning the Platen and Transfer Rollers ______________________________________________ 8-10Cleaning the Transfer Rollers using the Cleaning Card ___________________________________ 8-11Section 9: Packing the Card Printer__________________________________________ 9-12Section 10: Board Level Diagnostics _________________________________________ 10-1Board Errors ______________________________________________________________________ 10-2Resolving the EE Memory Error ____________________________________________________ 10-2Resolving the EE Checksum Error ___________________________________________________ 10-2Resolving the DRAM Memory Error _________________________________________________ 10-3Resolving the RAM Memory Error __________________________________________________ 10-3Resolving the FPGA Error _________________________________________________________ 10-4Sensor Testing _____________________________________________________________________ 10-4Reviewing the Sensor Locations and Voltages__________________________________________ 10-5Reviewing the Motor Locations and Cables____________________________________________ 10-7Section 11: LCD On-Line Menu Navigation ___________________________________ 11-1Entering the LCD Menu and selecting an Option __________________________________________ 11-1Selecting from the HDP600 Menu Option Structure Tree _________________________________ 11-2Reviewing the Printer Setup __________________________________________________________ 11-3Preparing to Adjust the Print Offset, Transfer TOF and Transfer EOF _______________________ 11-5Aligning the Print Offset __________________________________________________________ 11-6Setting the Transfer TOF __________________________________________________________ 11-8Setting the Transfer EOF _________________________________________________________ 11-10Using the Gap Distance Table _____________________________________________________ 11-12Adjusting the Transfer Tension ____________________________________________________ 11-15Adjusting the Film Drive _________________________________________________________ 11-16Adjusting the Ribbon Tension _____________________________________________________ 11-16Adjusting the Ribbon Drive _______________________________________________________ 11-17Adjusting the Transfer Temperature_________________________________________________ 11-17Adjusting the Transfer Speed ______________________________________________________ 11-18Setting the Printhead Resistance____________________________________________________ 11-18Adjusting the Image Darkness _____________________________________________________ 11-19Changing the Encoder Settings_____________________________________________________ 11-20Setting the Magnetic TOF ________________________________________________________ 11-21Setting the Magnetic TOF ________________________________________________________ 11-23Adjusting the Flipper Offset _______________________________________________________ 11-24Adjusting the Lamination Flipper Offset _____________________________________________ 11-25Adjusting the LAM TOF and EOF __________________________________________________ 11-26Adjusting the Lamination Sensor Calibration__________________________________________ 11-27Adjusting the Lamination Temperature Setting ________________________________________ 11-27Using the Show Card Count option _________________________________________________ 11-28System Upgrade (Firmware Upgrade) _______________________________________________ 11-29
