Falcon Elise 90 Dual Fuel User's Manual & Installation Instructions

13Shelf guardFrontAccessoriesOven Shelves – Left-hand (Main) OvenThe oven shelves (Fig. 2.19) can be easily removed andrefitted.Pull the shelf forward until the back of the shelf is stopped bythe shelf stop bumps in the oven sides (Fig. 2.20).Lift up the front of the shelf so the back of the shelf will passunder the shelf stop and then pull the shelf forward(Fig. 2.21).To refit the shelf, line up the shelf with a groove in the ovenside and push the shelf back until the ends hit the shelf stop.Lift up the front so the shelf ends clear the shelf stops, andthen lower the front so that the shelf is level and push it fullyback.Glide-out Shelf - Left-hand (Main) OvenAs well as standard shelves, the left-hand oven is suppliedwith runners for glide-out oven shelves.To fit the glide-out shelf, hook the front of the shelf onto therunners as shown (Fig. 2.22). The rear of the shelf should reston the runners, in front of the rear stop (Fig. 2.22).The glide-out shelf and runners can be easily removed orrepositioned.To remove the glide-out shelfRaise the rear of the shelf, so that it clears the rear stops. Thenunhook from the front locating bracket.To remove the glide-out runnersTwist to unclip the base of the runners from the shelfsupports. Then unhook the runner from the top rung of theshelf support and remove (Fig. 2.23).To refit the glide-out runnersHook the rear of the runner over the top rung of a pair of shelfsupports. Then hook the front of the runner onto the samerung. Push to clip under the bottom rung (Fig. 2.24).Ensure that the shelf runners are fitted in the same positionon each side (Fig. 2.25).The front of the shelf runners can be identified by the bracket(Fig. 2.22).nn DO NOT put the glide-out shelf runners in adishwasher.Oven Shelves – Right-hand (Tall) OvenThe tall oven is supplied with four flat cooking shelves(Fig. 2.26), and a plate-warming shelf (Fig. 2.27).When using the tall oven, you can cook on all four shelves atthe same time, but make sure that they are well spaced outallow the hot air to circulate.Fig. 2.1912ArtNo.320-0011 Removing the shelf 1 ArtNo.320-0012 Removing the shelf 2ArtNo.324-0002 Oven shelfArtNo.324-0010 Plate warming shelfFRONTRear stopFrontbracket21Fig. 2.20 Fig. 2.21Fig. 2.22Fig. 2.23 Fig. 2.24Fig. 2.25Fig. 2.26 Fig. 2.27