WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSONDisconnect from electricity before servicing. Check appliance is safe when you have finished.406.5 To Change the Left Hand Oven Door LatchRemove the outer door panel (see 6.4). Remove screws ‘B’,which hold the latch assembly to the inner door panel (Fig.12.16). Fit the new catch and reassemble in reverse order.Check the door operation.6.6 To Adjust Left Hand Oven Door Catch KeepOpen the oven door, slacken off the locknut at the base of thekeep, and screw in or out as required until the required fit isobtained. Retighten the locking nut (Fig. 12.17).6.7 To Change the Right-hand Oven Door CatchRemove the screws that secure the latch assembly to theframe (Fig. 10.16). Fit the replacement latch and re-assemblein reverse order.Check correct operation of door.6.8 To Remove the Tall Oven DoorOpen the oven door. Supporting the door, remove the 2screws securing the upper hinge and packing to the cookerfront. Remove the door from the lower hinge by liftingslightly and moving outwards.Reassemble in reverse order.6.9 To Replace the Tall Oven Door Outer PanelRemove the tall oven door (see 6.7). Lay the door face downon a suitable surface and remove the 2 screws from bottomedge of door and the 2 screws from the inside face of thedoor.Remove the outer door panel. Remove the door handle byunscrewing the 2 screws.Remove the 2 cross-headed screws holding the door handlefixing bracket to the door panel. Fit the door handle bracketand the door handle to the new panel.Fit the panel to the door and reassemble in reverse order.7.0 To Change an Oven Door SealOpen the oven door. The seal is held in place by small hookson the rear face. At the corner, pull the seal diagonally awayfrom the door centre until that hook is released (Fig. 12.19).Proceed to the next hook and release it in a similar way, andso on. Use force if the hooks are stiff, as the old seal will bediscarded.When fitting the new seal, position the seal join at thebottom. Hook the new seal in one of the corner holes of thedoor, and proceed round the door, snapping in each hook inturn.ArtNo.320-0005 Oven door rubber sealArtNo.320-0003 Oven door latchBArtNo.320-0004 Oven door keepFig. 12.16 Fig. 12.17Fig. 12.18Fig. 12.19