3-48 B90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUALADD DEVICE TO SOFTWARE CHAPTER 3: INSTALLATION3Before continuing, test the Ethernet connection.1. Open a Windows console window, for example by selecting Start > Run from the Windows Start menu and typing“cmd” or clicking the Start button and entering "cmd".2. Type the following command, substituting the IP address of 1.1.1.1 with yours:C:\WINNT>ping 1.1.1.13. If the connection is successful, the system returns four replies similar to the following:Pinging 1.1.1.1 with 32 bytes of data:Reply from 1.1.1.1: bytes=32 time<10ms TTL=255Reply from 1.1.1.1: bytes=32 time<10ms TTL=255Reply from 1.1.1.1: bytes=32 time<10ms TTL=255Reply from 1.1.1.1: bytes=32 time<10ms TTL=255Ping statistics for 1.1.1.1:Packets: Sent = 4, Received = 4, Lost = 0 (0% loss),Approximate round trip time in milliseconds:Minimum = 0ms, Maximum = 0ms, Average = 0 ms4. Note that the values for time and TTL vary depending on local network configuration.5. If the following sequence of messages appears when entering the C:\WINNT>ping 1.1.1.1 command:Pinging 1.1.1.1 with 32 bytes of data:Request timed out.Request timed out.Request timed out.Request timed out.Ping statistics for 1.1.1.1:Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),Approximate round trip time in milliseconds:Minimum = 0ms, Maximum = 0ms, Average = 0 msPinging 1.1.1.1 with 32 bytes of data:verify the physical connection between the B90 and the computer, and double-check the programmed IP address inthe Product Setup Communications Network IP Address setting, then repeat step 2.6. If the following sequence of messages appears when entering the C:\WINNT>ping 1.1.1.1 command:Pinging 1.1.1.1 with 32 bytes of data:Hardware error.Hardware error.Hardware error.Hardware error.Ping statistics for 1.1.1.1:Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),Approximate round trip time in milliseconds:Minimum = 0ms, Maximum = 0ms, Average = 0 msPinging 1.1.1.1 with 32 bytes of data:verify the physical connection between the B90 and the computer, and double-check the programmed IP address inthe PRODUCT SETUP COMMUNICATIONS NETWORK IP ADDRESS setting, then repeat step 2.7. If the following sequence of messages appears when entering the C:\WINNT>ping 1.1.1.1 command:Pinging 1.1.1.1 with 32 bytes of data:Destination host unreachable.Destination host unreachable.Destination host unreachable.Destination host unreachable.Ping statistics for 1.1.1.1:Packets: Sent = 4, Received = 0, Lost = 4 (100% loss),Approximate round trip time in milliseconds:Minimum = 0ms, Maximum = 0ms, Average = 0 msPinging 1.1.1.1 with 32 bytes of data:verify the IP address is programmed in the local computer by entering the ipconfig command in the commandwindow.C:\WINNT>ipconfig
