GE Multilin F60 Feeder Protection System 5-1415 SETTINGS 5.4 SYSTEM SETUP5k) PMU RECORDINGPATH: SETTINGS SYSTEM SETUP PHASOR MEASUREMENT PHASOR MEASUREMENT UNIT1 RECORDING PMU1• PMU 1 FUNCTION: This setting enables or disables the recorder for PMU 1. The rate is fixed at the reporting rate setwithin the aggregator (that is, Aggregator 1).• PMU 1 NO OF TIMED RECORDS: This setting specifies the number of timed records that are available for a given log-ical PMU 1. The length of each record is equal to the available memory divided by the content size and number ofrecords. As the number of records is increased the available storage for each record is reduced. The relay supports amaximum of 128 records in either timed or forced mode.• PMU 1 TRIGGER MODE: This setting specifies what happens when the recorder uses its entire available memorystorage. Under the “Automatic Overwrite”, the last record is erased to facilitate new recording, when triggered. Underthe “Protected” selection, the recorder stops creating new records when the entire memory is used up by the old un-cleared records.• PMU 1 TIMED TRIGGER POSITION: This setting specifies the amount of pre-trigger data as a percent of the entirerecord. This setting applies only to the timed mode of recording.l) AGGREGATORPATH: SETTINGS SYSTEM SETUP PHASOR MEASUREMENT UNIT PMU AGGREGATOR 1When the protocol selection is set via the software or keypad, all aggregators whose protocol is not set to None areset to the last protocol saved (that is, IEEE C37.118 or IEC 61850-90-5) to any aggregators, as both IEEE C37.118and IEC 61850-90-5 simultaneous streaming is not possible.PATH: SETTINGS SYSTEM SETUP PHASOR MEASUREMENT UNIT PMU AGGREGATOR 1 37.118 AGGR 1 CONFIGURA-TION PMU 1 RECORDINGPMU 1 FUNCTIONDISABLERange: Enable, DisableMESSAGE PMU 1 NO OF TIMEDRECORDS: 10Range: 2 to 128 in steps of 1MESSAGE PMU 1 TRIGGER MODE:AUTOMATIC OVERWRITERange: Automatic Overwrite, ProtectedMESSAGE PMU 1 TIMED TRIGGERPOSITION: 10%Range: 1 to 50% in steps of 1 PMU AGGREGATOR 1PMU AGGREGATOR 1PROTOCOL: NONERange: NONE, 37.118, 90-5MESSAGE PMU AGGREGATOR 1:IDCODE: 1Range: 1 to 65534 in steps of 1MESSAGE PMU AGGREGATOR 1INCLUDE PMU1: NoRange: No, YesMESSAGE 37.118 AGGR 1 CONFIGURATION See below.MESSAGE 90-5 AGGR 1 CONFIGURATION See below. 37.118 AGGR 1 CONFIGURATIONPMU AGGREGATOR 1TCP PORT: 4712Range: 1 to 65534MESSAGE PMU AGGREGATOR 1UDP PORT: 4713Range: 1 to 65534MESSAGE PMU AGGREGATOR 1PDC CONTROL: DisabledRange: Disabled, EnabledNOTE
