GE Multilin F60 Feeder Protection System H-3APPENDIX H H.1 CHANGE NOTESH5-23 5-23 Add Added Syslog Format section5-31 5-31 Add Added Far-End Fault Indication (FEFI) sectionB- B- Update Updated Modbus memory map and F codesH-8 H-8 Update Updated product warranty from 24 months to 10 yearsTable H–4: MAJOR UPDATES FOR F60 MANUAL REVISION AA1PAGE(Z1)PAGE(AA1)CHANGE DESCRIPTION--- --- Add Added content for IEC 60870-5-103 throughout document2- 2- Update Updated order codes2- 2- Update Updated specifications5-117 5-117 Update Updated hysteresis numbers and logic diagrams in section 5.4.7 Phasor Measurement Unit5-175 5-175 Update Updated Neutral Directional Overcurrent settings to include Dual-V and Dual-I settings to reflectenhanced polarity criteria8- --- Delete Deleted chapter 8 on security, moving content to other chapters--- 10- Add Added Maintenance chapter, moving content from other chapters and adding new instructions toreplace the battery--- D- Add Added new appendix on IEC 60870-5-103 interoperabilityTable H–5: MAJOR UPDATES FOR F60 MANUAL REVISION Z1PAGE(Y3)PAGE(Z1)CHANGE DESCRIPTION--- --- Add Added CPU options U and V to order code tables in chapter 2, a note above Rear Terminal Viewfigure in chapter 3, and CPU Module Communications Wiring figure in chapter 3--- --- Add Added Parallel Redundancy Protocol (PRP) to order code tables and specifications in chapter 2,section 5.2.5d Settings > Product Setup > Communications > Network, section 6.3.1 ActualValues > Status > PRP, and Appendix B Modbus table and F627 and F628 enumeration tables1-1 1-1 Add Added General Cautions and Warnings to section 1.1.11-5 1-5 Update Revised section 1.3.1 on system requirements, including addition of support for Windows 7 andWindows Server 20082-10 2-10 Update Updated several specifications5-24 5-24 Add Added section 5.2.5e Routing5-91 5-91 Update Updated Figures 5-25 and 5-26 Dual Breaker Control Scheme Logic, sheets 1 and 25-95 5-95 Update Updated Figure 5-27 Disconnect Switch Scheme Logic5-263 5-263 Add Reinserted section 5.8.5c Remote Devices: ID of Device for Receiving GSSE/GOOSE Messages,meaning the Settings > Input/Outputs > Remote Devices settingsTable H–6: MAJOR UPDATES FOR F60 MANUAL REVISION Y3PAGE(Y2) PAGE(Y3) CHANGE DESCRIPTION-- xi Add Added battery disposal information as chapter 0Table H–3: MAJOR UPDATES FOR F60 MANUAL REVISION AA2 (Sheet 2 of 2)PAGE(AA1)PAGE(AA2)CHANGE DESCRIPTION
