CHAPTER 4: INTERFACES FLEXLOGIC DESIGN AND MONITORING USING ENGINEERL60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL 4-494Figure 4-53: Unused pins on and off4.4.6.2 Logic designerThe path is File > Preferences > Logic Designer.Workbook SetupSize and UnitsSize and Units — Changes the size of diagram area displayed in Engineer. If you set the size to be smaller than an existinglogic diagram, the content is cut off.WorkBookPrint Scale — The scale for logic diagram when printing. Scaling a large diagram to 200 percent, for example, results in thediagram being cut off.Orphan Protection — When enabled, the printing output prevents Virtual Output circuits from spanning more than a singlepage. The largest Virtual Output circuit is scaled to fit on a single page and all remaining Virtual Output circuits are scaledso that all circuits are printed using the same scale.Show Title Block — When enabled, places an information box at the bottom right of the diagram when printing. Enter theinformation in the File Information panel.Show Sheet Name — When enabled, shows Sheet 1, Sheet 2, or any other name at the top of the logic diagram whenprinting.Start Sheet On New Page — Places the sheet on the next page when printing.Show Notes Selection — When other than None, prints the text from any information notes added to the document (underDrawing Tools tab > Note). The text is printed after the logic diagram.File InformationThe text entered here displays at the bottom right of a diagram when printing, provided that the Show Title Block option isenabled. Note the option to change the logo from the GE logo to your company logo.DisplayThe panel sets how the element boxes display. The figure shows how an AND gate displays when the UR default, IEC, orISO symbol type is selected.Figure 4-54: AND gate varies by standard selectedSymbol Style — IEC, ISO, UR Setup — Sets how the gates display in the logic diagram.Symbol Color — When set to Black & White, only logic blocks with issues continue to display red.
