4-56 L60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUALFLEXLOGIC DESIGN AND MONITORING USING ENGINEER CHAPTER 4: INTERFACES44.4.7.3 Basic Actions toolbarPlace and configure a FlexElement. A FlexElement is a universal comparator used to monitor any analog actual valuecalculated by the relay or a net difference of any two analog actual values of the same type.Place and configure the Settings Group settingsPlace and configure a Selector Switch element. Firmware version determines feature availability. The Selector Switchelement is intended to replace a mechanical selector switch. Typical applications include setting groupcontrol or control of multiple logic sub-circuits in user-programmable logic. The element provides for two control inputs.Place and configure a Digital Element. A Digital Element can monitor any FlexLogic operandand present a target message and/or enable events recording depending on the output operand state.Place and configure a Digital Counter element. A Digital Counter counts the number of state transitionsfrom Logic 0 to Logic 1. The counter is used to count operations such as the pickups of an element.Select Select components. Click one component and hold down the CTRL key to select others.Or click and drag an area that contains multiple components to select.Edit Vertices Shows vertices points for the component selected (if the component support verticesmanipulation)Properties Shows the properties of the selected componentZoom Normal Zoom in and center the screen to the spot selectedZoom to Fit Zoom in to a magnitude that fits your entire schema layout on your entire screenZoom Custom Zoom in on the components that you have selectedPan Move the viewable area of your screen around the schema. To activate, select this tooland then place the hand icon over and part of your schema. Click and drag the hand ina direction to move around the schema.Align Top, Middle, Bottom Align the selected components to the top, middle, or bottom of the referencecomponentAlign Left, Center, Right Align the selected components to the left, middle, or right of the reference componentSpace Across Evenly space the selected components across a horizontal axis, starting from the farleft component and ending at the far right componentSpace Down Evenly space the selected components across a vertical axis, starting from the topcomponent and ending at the bottom componentSame Width Set the width of the selected components to the same width as the referencecomponentSame Height Set the height of the selected components to the same height as the referencecomponent
