APPENDIX D: MISCELLANEOUS REVISION HISTORYL60 LINE PHASE COMPARISON SYSTEM – INSTRUCTION MANUAL D-3DTable D-3: Major changes for L60 manual version AC1 (English)Table D-4: Major changes for L60 manual version AB2 (English)Table D-5: Major changes for L60 manual version AB1 (English)Page Description--- General revision. Added online help and updated generic online help.--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document nottranslated into Russian--- Updated Breaker Arcing Current content, including FlexLogic operands table, settings, logic diagram, actual values, Modbusmemory map--- Updated Synchrocheck content including settings, logic diagram, actual values, and number of elements in interface chapter,FlexLogic operands table, settings, actual values, FlexAnalog table, features per product table, Modbus memory map, IMDtables--- Updated Fault Report and Fault Location content, including settings, actual values, and theory of operation chapters, andModbus memory map. Increased number of elements to two.--- Added Compensated Overvoltage content to product description, specifications, FlexLogic operands table, settings, featuresper product table, Modbus memory map, IMD tables--- Updated CT Fail number from 6 to 4 in settings, feature per product list, Modbus memory map, as per feature per producttable--- Added Broken Conductor Detection content to FlexLogic operands table, settings, features per product table, Modbusmemory map, IMD table--- Added Breaker Restrike content to product description, specifications, FlexLogic operands table, settings, features perproduct table, Modbus memory map, IMD table--- Updated Disconnect (Breaker) Switch number from 16 to 8 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated Neutral Time Overcurrent (TOC) number from 4 to 2 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated Phase Time Overcurrent (TOC) number from 4 to 2 in FlexLogic operands table, settings, features per product table,Modbus memory map--- Updated VT Fuse Failure (VTFF) number from 4 to 2 in FlexLogic operands table, settings, features per product table, Modbusmemory map2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port5-49 Updated IEC 61850 section5-170 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section5-213 Updated Zone 1 and 2 ground distance logic diagrams to include IG10-1 Added Monitoring section10-2 Added Retrieve Files sectionC- Added Command Line Interface appendixPage Description--- Updated document throughout, including numbers of elements and FlexLogic operands table--- Added EAC compliance information throughout, including logo on title page, rear panel, added specifications, added lifeexpectancy and decommissioning, added sections on Repairs, Storage, and Disposal--- Updated several figures for consistency2-13 Added UR Signal Processing section5- Updated IEC 61850 contentA- Updated FlexAnalog tablePage Description--- Updated document throughout and put into new template. Major revision.--- Updated references to digital inputs/outputs to contact inputs/outputs for consistency
