Garmin G1000 Cockpit Reference Guide for the Quest KODIAK™ 100 190-00645-07 Rev. A2Flight InstrumentsFlightInstrumentsEISNav/Com/XPDR/AudioAFCSGPS NavFlightPlanningProceduresHazardAvoidanceAdditionalFeaturesAbnormalOperationAnnun/AlertsAppendixIndexSETTING THE BARO TRANSITION ALERT1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.2) Press the FMS Knob to activate the cursor.3) Turn the large FMS Knob to highlight Altitude in the Baro Transition Alertbox.4) Turn the small FMS Knob to turn the alert OFF or ON and press the ENTKey.5) Turn the small FMS Knob to change the altitude and press the ENT Key.6) To cancel the selection, press the FMS Knob.CHANGING THE HSI DISPLAY FORMAT1) Press the PFD Softkey2) Press the HSI FRMT Softkey.3) Press the 360 HSI or ARC HSI Softkey.CHANGING THE NAVIGATION ANGLE TRUE/MAGNETIC SETTING1) Use the FMS Knob to select the AUX - System Setup Page on the MFD.2) Press the FMS Knob to activate the cursor.3) Turn the large FMS Knob to highlight Nav Angle in the Display Units box.4) Turn the small FMS Knob to highlight the desired setting and press theENT Key.• TRUE - References angles to true north (T)• MAGNETIC - Angles corrected to the computed magnetic variation (MagVar)SELECTING BEARING DISPLAY AND CHANGING SOURCES1) Press the PFD Softkey.2) Press a BRG Softkey to display the desired bearing pointer and informationwindow with a NAV source.3) Press the BRG Softkey again to change the bearing source to GPS.4) To remove the bearing pointer and information window, press the BRGSoftkey again.
