Garmin G1000 Cockpit Reference Guide for the Quest KODIAK™ 100190-00645-07 Rev. A35Flight PlanningFlightInstruments EISNav/Com/XPDR/Audio AFCS GPS NavFlightPlanning ProceduresHazardAvoidanceAdditionalFeaturesAbnormalOperationAnnun/Alerts Appendix Indexd) Press the ENT Key.e) Press the ENT Key again to accept the waypoint.Or:a) Turn the small FMS Knob to the left. Initially, a flight plan waypoint listis displayed.b) Turn the small FMS Knob to the right to display the ‘USER’ waypoints.c) Turn the large FMS Knob to select the desired user waypoint.d) Press the ENT Key.6) Press the ENT Key again to “accept” the waypoint.ENTER AN AIRWAY IN A FLIGHT PLAN1) Press the FPL Key.2) Press the FMS Knob to activate the cursor (not required on the PFD).3) Turn the large FMS Knob to highlight the waypoint after the desired airwayentry point. If this waypoint is not a valid airway entry point, a valid entrypoint should be entered at this time.4) Turn the small FMS Knob one click clockwise and press the LD AIRWYSoftkey, or press the MENU Key and select ‘Load Airway‘. The Select AirwayPage is displayed. The LD AIRWY Softkey or the ‘Load Airway‘ menuitem is available only when an acceptable airway entry waypoint has beenchosen (the waypoint ahead of the cursor position).5) Turn the FMS Knob to select the desired airway from the list, and press theENT Key. Low altitude airways are shown first in the list, followed by “all”altitude airways, and then high altitude airways.6) Turn the FMS Knob to select the desired airway exit point from the list, andpress the ENT Key. ‘LOAD?’ is highlighted.7) Press the ENT Key. The system returns to editing the flight plan with thenew airway inserted.CREATING A USER-DEFINED HOLD AT AN ACTIVE FLIGHT PLAN WAYPOINT1) Press the FPL Key to display the Active Flight Plan Page (MFD) or the ActiveFlight Plan Window (PFD).2) Press the FMS Knob to activate the cursor (not required on the PFD) andturn the large FMS Knob to highlight the waypoint for the hold.
