Part No. 34032 Genie S-80 & Genie S-85 7 - 29Service Manual - First Edition Section 7 - Repair ProceduresGROUND CONTROLS8-2Toggle SwitchesSee 1-5, Toggle Switches.8-3Wago® ComponentsHow to Remove a Wago®ComponentElectrocution hazard.Contact with electrically chargedcircuits may cause death orserious injury. Remove all rings,watches and other jewelry.A small screwdriver is providedand should be used whenremoving a Wago® component.This screwdriver is located in theoperator’s manual storage box inthe platform.1 Label the wiring from the component to beremoved.2 Use the provided screwdriver to push in andrelease the wire from the component.3 Locate the removal tab on the bottom or topside of the component.4 Use the provided screwdriver to gently pry upon the tab of the component and remove it.8-4ResistorsHow to Test the ResistorThe resistor is used to maintain proper control ofboom function speeds. A 10 ohm resistor reducesvoltage to all the boom function switches.Refer to the schematic legends forresistor locations and values.1 Turn the key switch to the OFF position.2 Disconnect either end of one of the wiresconnected to the resistor to be tested.3 Connect the leads from an ohmmeter to eachend or wiring of the resistor being tested.4 Compare the ohmmeter reading with theresistance rating printed on the resistor.
