Part No. 34032 Genie S-80 & Genie S-85 4 - 17Service Manual - First Edition Section 4 - Scheduled Maintenance ProceduresTurntable Rotate Torque Hub1 Remove the plug located on the side of the huband check the oil level.Result: The oil level should be even with thebottom of the plug hole.a torque hubb plug2 If necessary, add oil until the oil level is evenwith the bottom of the side plug hole.3 Apply pipe thread sealant to the plug, and theninstall it in the torque hub.Turntable rotate torque hub oilCapacity 44 fluid ounces1.30 litersType SAE 90 multipurpose hypoid gear oil - API serviceclassification GL5TABLE B PROCEDURESB-11Check and Adjust the Engine IdleMixture - Gasoline/LPG ModelsComplete information to perform this procedure isavailable in the Ford LSG-423 2.3 Liter IndustrialEngine Service Manual (Ford number: 194-216).Genie part number 29586.B-12Check and Adjust theEngine RPMMaintaining the engine rpm at the proper settingfor both low and high idle is essential to goodengine performance and service life. The machinewill not operate properly if the rpm is incorrect andcontinued use may cause component damage.Gasoline/LPG ModelsPerform this procedure in gasolinemode with the engine at normaloperating temperature.1 Disconnect the blue/black wire from thegovernor actuator.ba
