4 - 26 Genie S-80 & Genie S-85 Part No. 34032Service Manual - First EditionSection 4 - Scheduled Maintenance ProceduresTABLE B PROCEDURESa engine oil level dipstickb oil filterc fuel filter6 Apply a thin layer of oil to the new filter gasket(filter part no. 29561). Then install the filter andtighten it securely by hand.7 Use a permanent ink marker to write the dateand number of hours from the hour meter onthe oil filter.8 Fill the engine with new oil per specificationsand replace the oil filler cap.9 Start the engine from the ground controls.Allow the engine to run for 30 seconds thenturn the engine off.10 Check the oil filter and oil pan for leaks.11 Check the engine oil level dipstick. Add oil ifneeded.Deutz Engine F4L 1011 11 quartsOil capacity (including filter) 10.5 litersDeutz Engine F4L 1011 Oil viscosity requirementsTemperature below 60°F / 15.5°C (synthetic) 5W-30-10°F to 90°F / -23°C to 32°C 10W-40Temperature above -4°F / -34°C 15W-40Engine oil should have properties of API classificationCC/SG or CD/SG grades.abcB-27Replace the Engine Oil andFilter - Deutz Diesel ModelsEngine specifications requirethat this procedure be performedevery 500 hours. Perform thisprocedure more often if dustyconditions exist.Periodic replacement of the engine oil andfilter is essential to good engine performance.Operating the machine with an improper oil levelor neglecting periodic oil and filter changes candamage engine components. A frequent checkof elapsed machine hours against the hoursnoted on the oil filter will allow the inspector toanticipate and perform oil and filter changes atthe 500 hour interval.Perform this procedure afterwarming the engine to normaloperating temperature.Beware of hot engine parts andoil. Contact with hot engine oiland/or engine parts may causesevere burns.1 Remove the oil filler cap located on thevalve cover.2 Pull the end of the drain hose out from underthe engine.3 Remove the plug from the end of the drainhose and allow all of the oil from the engine todrain into a suitable container.4 Install the plug into the drain hose.5 Use an oil wrench and remove the oil filter.
