Part No. 34032 Genie S-80 & Genie S-85 4 - 29Service Manual - First Edition Section 4 - Scheduled Maintenance ProceduresTABLE C PROCEDURESC-5Grease the Turntable RotationBearing and Rotate GearYearly application of lubrication to the turntablebearing and rotate gear is essential to goodmachine performance and service life. Continueduse of an improperly greased bearing and gear willresult in component damage.1 Locate the grease fitting on the platform end ofthe tank side bulkhead.2 Pump grease into the turntable rotationbearing. Rotate the turntable in incrementsof 4 to 5 inches (10 to 13 cm) at a time andrepeat this step until the entire bearing hasbeen greased.3 Apply grease to each tooth of the drive gear,located under the turntable.Oil type Multipurpose greaseC-6Replace the Torque Hub OilReplacing the torque hub oil is essential for goodmachine performance and service life. Failure toreplace the torque hub oil at yearly intervals maycause the machine to perform poorly andcontinued use may cause component damage.Drive Torque Hubs:1 Select the torque hub to be serviced. Thendrive the machine until one of the two plugs isat the lowest point.2 Remove both plugs and drain the oil.10 Disengage the torque hubs by turning over thetorque hub disconnect caps on eachsteer wheel hub.11 Manually rotate each steer wheel.Result: Each steer wheel should rotate withminimum effort.12 Re-engage the torque hubs by turning overthe hub disconnect caps. Rotate each wheel tocheck for engagement. Lift the machine andremove the jack stands.Collision hazard. Failure tore-engage the torque hubs maycause death or serious injury andproperty damage.All models:13 Be sure the free-wheel valve on the drive pumpis closed (clockwise).a drive pumpb free-wheel valvec screwdriverd lift pumpThe free-wheel valve shouldalways remain closed.a b dcdisengage positionengage position
