Part No. 34032 Genie S-80 & Genie S-85 4 - 7Service Manual - First Edition Section 4 - Scheduled Maintenance ProceduresTABLE A PROCEDURESA-13Test the Tilt SensorThe tilt sensor sounds an alarm in the platformwhen the incline of the turntable exceeds4.5 degrees.Select a level test area. The tiltalarm should not be soundingprior to test.1 Start the engine from the platform controls.2 Open the tank side cover and press down onone side of the tilt sensor.Result: After a 1.5 second delay, the alarm inthe platform should sound.a fuel tankb tilt sensorc ground control boxcba3 Turn the key switch to platform control.4 At the platform controls, pull out the EmergencyStop button to the ON position, then press downthe foot switch.5 Simultaneously hold the auxiliary power switchon while activating the following functionsthrough a partial cycle:· jib boom up/down (S-85 models)· boom up/down· extend and retract· turntable rotate right/left· steer right/leftResult: Each function should operate smoothly.Auxiliary power will not lift theboom past the drive limit switchunless the axles are fullyextended.
