4 - 28 Genie S-80 & Genie S-85 Part No. 34032Service Manual - First EditionSection 4 - Scheduled Maintenance ProceduresTABLE C PROCEDURES2 Be sure that each turntable mounting bolt istorqued in sequence to 210 foot-pounds(285 Newton meters).3 Lower the boom to the stowed position.4 Check to ensure that each bearing mountingbolt under the drive chassis is torqued insequence to 210 foot-pounds(285 Newton meters).Non-steering wheels: All models1 Chock the steer wheels to prevent the machinefrom rolling.2 Center a lifting jack of ample capacity(20,000 lbs/9072 Kg) under the drive chassisbetween the non-steer tires.3 Lift the wheels of the ground and then placejack stands under the drive chassis for support.4 Disengage the torque hubs by turning over thetorque hub disconnect caps on eachnon-steering wheel hub.5 Manually rotate each non-steering wheel.Result: Each non-steering wheel should rotatewith minimum effort.6 Re-engage the torque hubs by turning overthe hub disconnect caps. Rotate each wheel tocheck for engagement. Lift the machine andremove the jack stands.Collision hazard. Failure tore-engage the torque hubs maycause death or serious injury andproperty damage.Steer wheels: 4WD models7 Chock the non-steering wheels to prevent themachine from rolling.8 Center a lifting jack of ample capacity(20,000 lbs/9072 Kg) under the drive chassisbetween the non-steer tires.9 Lift the wheels of the ground and then placejack stands under the drive chassis for support.disengage positionengage positionC-4Check the Free-wheelConfigurationProper use of the free-wheel configuration isessential to safe machine operation. Thefree-wheel configuration is used primarily fortowing. A machine configured to free-wheelwithout operator knowledge may cause death orserious injury and property damage.Collision hazard. Select a worksite that is firm and level.Bolt torque sequence1 15712417514921681131861310Bolt torque sequence1234567891011121314 1516171822263019232720 24 28212529
