IBM Aptiva 2159 Manual

Also see for Aptiva 2159: Hardware maintenance service

2080—Lithium Battery Adapter cards (2035) if applicable. Riser card (2045). Insert the tip of a screwdriver (1) under the clip and raise the clip (2)carefully to remove the battery.See Safety Notice 2: Translation on page xiiThe lithium battery can cause a fire, explosion, or severe burn. Do notrecharge it, remove its polarized connector, disassemble it, heat it above100°C (212°F), incinerate it, or expose its cell contents to water.Dispose of the battery as required by local ordinances or regulations.Use only the battery in the appropriate parts listing. Use of an incorrectbattery can result in ignition or explosion of the battery.Attention: Be careful when removing the battery. If the retaining clip isbroken, the system board must be replaced.Note: Run the Setup Utility after installing a battery.12BatteryRetainingClipFigure 4-17. Lithium Battery4-16