v Ethernet firmware is stored in ROM on the Ethernet controller.v ServeRAID firmware is stored in ROM on the ServeRAID adapter.v SATA firmware is stored in ROM on the integrated SATA controller.v SAS/SATA firmware is stored in ROM on the SAS/SATA controller on thesystem board.Configuring UEFI compatible devicesUse this information to configure UEFI compatible devices.About this taskUEFI compatible expansion cards can be configured through the Setup utility. Toconfigure a UEFI compatible expansion card, complete the following steps:Note: Before configuring a UEFI compatible device, it is recommended to updatethe firmware for your server. See “Updating the firmware” on page 87 forinformation on how to update the firmware for your server.1. Run the Setup utility (see “Using the Setup utility” on page 91).2. Select System Settings → Network or Storage depending on the type of youradapters.Note: Select System Settings → Adapters and UEFI drivers for UEFI 2.0 (andprior) compliant adapters and drivers installed in the server.3. Select Please refresh this page first and press Enter.4. Select the device driver that you want to configure and press Enter.5. When you have finished changing settings, press Esc to exit from the program;select Save to save the settings that you have changed.Configuring the serverThe following configuration programs come with the server:v Setup utilityThe UEFI Setup Utility program is part of the basic input/output systemfirmware. Use it to change interrupt request (IRQ) settings, change thestartup-device sequence, set the date and time, and set passwords. Forinformation about using this program, see “Using the Setup utility” on page 91.v Boot Manager programThe Boot Manager program is part of the server firmware. Use it to override thestartup sequence that is set in the Setup utility and temporarily assign a deviceto be first in the startup sequence. For more information about using thisprogram, see “Using the Boot Manager program” on page 98.v IBM ServerGuide Setup and Installation CDThe ServerGuide program provides software-setup tools and installation toolsthat are designed for the server. Use this CD during the installation of the serverto configure basic hardware features, such as an integrated SAS/SATA controllerwith RAID capabilities, and to simplify the installation of your operating system.For information about using this CD, see “Using the ServerGuide Setup andInstallation CD” on page 90.v IBM FastSetupIBM FastSetup is a no-cost software tool that helps simplify the maintenance anddeployment of selected IBM BladeCenter chassis, servers, and components. The88 System x3650 M4 BD Type 5466: Installation and Service Guide
