Installing a single / dual port 10GbE SFP+ embedded adapterwith interposerUse this information to install a single / dual port 10GbE SFP+ embedded adapterwith interposer.About this taskNote:v To confirm that server supports the adapter that you are installing, seehttp://www.ibm.com/systems/info/x86servers/serverproven/compat/us/.v Locate the documentation that comes with the adapter and follow thoseinstructions in addition to the instructions in this section.To install an adapter, complete the following steps:Procedure1. Read the safety information that begins on page “Safety” on page vii and“Installation guidelines” on page 32.2. Turn off the server (see “Turning off the server” on page 22) and all attachedperipheral devices. Disconnect all power cords; then, disconnect all externalcables from the server.3. Remove the server top cover (see “Removing the server top cover” on page35).4. Rotate the hot-swap rear hard disk drive cage up (see “Rotating the hot-swaprear hard disk drive cage up” on page 36.5. Remove the PCI riser-card assembly (see “Removing a PCI riser-cardassembly” on page 37.6. Rotate the retention latch to the open position. Insert the adapter into the PCIriser-card assembly, aligning the edge connector on the adapter with theconnector on the PCI riser-card assembly. Press the edge of the connectorfirmly into the PCI riser-card assembly. Make sure that the adapter snaps intothe PCI riser-card assembly securely.48 System x3650 M4 BD Type 5466: Installation and Service Guide
