4. Install the screws to secure the front USB connector assembly to the side of theserver.5. Install the screws to secure the cable arm cover to the server.Note: The cable is routed on the outside of the chassis and connected to theUSB connector board. The cable must be protected by the cable cover on theside of the chassis.6. Install the server top cover (see “Replacing the server top cover” on page 260).7. Reconnect the external cables; then, reconnect the power cords and turn on theperipheral devices and the server.Removing the upper power supply card from the power-supplypaddle card assemblyUse this information to remove the upper power supply card from thepower-supply paddle card assembly.About this taskNote: The power-supply paddle card assembly includes the upper and lowerpower supply paddle cards.To remove the upper power supply card, complete the following steps:Procedure1. Read the safety information that begins on page “Safety” on page vii and“Installation guidelines” on page 32.2. Turn off the server (see “Turning off the server” on page 22) and all attachedperipheral devices. Disconnect all power cords; then, disconnect all externalcables as necessary to replace the device.3. Remove the server cover (see “Removing the server top cover” on page 258).4. Remove the power supply out of the server to disconnect it from thepower-supply paddle card assembly.Figure 131. Front USB connector assembly installation220 System x3650 M4 BD Type 5466: Installation and Service Guide
